03-30-2012 04:16 AM - edited 03-16-2019 10:23 AM
Hi,
I have configured a CME 8.6 router with 20+ dial peers. I would like these to appear in the config based upon the numeric value assigned to the dial peer.
It seems that they appear based upon the order of configuration.
Is there any way (short of manually editing the config file and then uploading it) to reorder them?
I do not think this is possible but would like confirmation of this.
Thanks
Solved! Go to Solution.
03-30-2012 04:31 AM
Hi
It will come in order of configuratoin only.....you can remove the config and put the edit one again.
Regards
Ronak patel
Please rate helpful posts.
03-30-2012 04:31 AM
Hi
It will come in order of configuratoin only.....you can remove the config and put the edit one again.
Regards
Ronak patel
Please rate helpful posts.
03-30-2012 05:51 AM
Thanks Ronak,
I did not think this was possible but it is good to have that confirmed.
03-30-2012 06:21 AM
Hi James
I think a reboot re-orders them. Or at least it used to...
Aaron
03-30-2012 06:39 AM
Hi Aarron,
Thanks for the response.
I have just tried a reboot and the dial peers remain in the order entered
I am running IOS 15.2. I will try this on some older verions when I get a chance.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: