I have a CME system which has installed a VWIC-1MFT-T1. The configuration has been completed with this card. It turns out the customer needs a VWIC-1MFT-E1. Is there anything I should be aware of when swapping these over?
I would usually save the running config, power down, replace the VWIC, then power up. Is there anything I would need to do before powering down to remove the vwic-T1 from my config? Would anything in the config interfere with the new VWIC-E1? What, if any, sections would be changed/removed?
This is the first time i've done a switch like this and i'm trying to make it go as smooth as possible.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.