Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restore CM 4.1(2) to 4.1(3)

Hi

I need to rebuild and then restore a backup of CM 4.1.2 but I cannot find the disks. Is there any way I can use 4.1(3) disks and restore into that.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Restore CM 4.1(2) to 4.1(3)

Hi Michael,

Sorry to say, this is not a supported method :( Here is a clip from the CCM 4.1(2) Backup and Restore documentation;

Do a system restore on the same Cisco CallManager version. Changes from release to release cause problems if you try to restore from a different version.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_troubleshooting_guide_chapter09186a00802e0e9d.html

Hope this helps!

Rob

1 REPLY
Hall of Fame Super Red

Re: Restore CM 4.1(2) to 4.1(3)

Hi Michael,

Sorry to say, this is not a supported method :( Here is a clip from the CCM 4.1(2) Backup and Restore documentation;

Do a system restore on the same Cisco CallManager version. Changes from release to release cause problems if you try to restore from a different version.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_troubleshooting_guide_chapter09186a00802e0e9d.html

Hope this helps!

Rob

89
Views
0
Helpful
1
Replies