Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Restore error in CCM Disaster Recovery System

I managed two CCM PUB & SUB.

One CCM(PUB) occured to fail booting, CCM(SUB) was ok.

Now CCM(SUB) is working IPT service.

For recover this, I reinstall CCM(PUB).

I Backup CCM database & config with Disaster Recovery System from CCM(SUB).

And I restore DATA to new-installed CCM(PUB).

But restore failed with following log.

============== error log message =========

Log File: 2007-10-02-23-25-43_r_ccm1_ccm_ccmdb.log ==========

Server : CCM1

Feature : CCM

Component : CCMDB

Time Completed: 2007-10-02-23-34-37

Result Code : 1

Result String : ERROR


Dropping DB ccm0500v0000

Setting DB to multi user mode

Restoring DB...

CCMDB Restore failed, installdb failed

----> BEGIN Standard Output

Inside getdbnameFromodbc...

Line Matched:


csv file validation in progress...

Validate CSV complete.

Stopping DbMon

Service Manager is running

Cisco Database Layer Monitor[STOPPING]

Cisco Database Layer Monitor[STOPPING]

Component is not running

Cisco Database Layer Monitor[NOTRUNNIG]

Shutting down Replication -- teardowndrf

Setting DB to single user mode

Dropping DB ccm0500v0000

Setting DB to multi user mode

Restoring DB...

Create database failed, check .../createdb.log

Failure 1

CCMDB Restore failed, installdb failed, error:


Restore failed.

----> END Standard Output

----> BEGIN Standard Error

+ '[' 3 -lt 3 ']'

+ sudo -u root /usr/local/cm/bin/ /common/drf/restore.log

/common/drf/status.txt /common/drf/2007-10-


command failed -- Enterprise Replication not active (62)

Database selected.

425: Database is currently opened by another user.

107: ISAM error: record is locked.

Error in line 1

Near character position 26

Database closed.

+ res=1

+ '[' 1 == 0 ']'

+ echo 'Restore failed.'

+ exit 1

----> END Standard Error


Re: Restore error in CCM Disaster Recovery System

You cannot take a Backup from the Subscriber and install it on the Publisher. Backup should always be taken from the Publisher and then restored.

Incase you dont have a valid backup of the Publisher, I dont think you can do a DRS Restore.

New Member

Re: Restore error in CCM Disaster Recovery System

Hi Drazik,

I also have the same error. I only turn on the  Publisher, I stop Cisco Database Layer Monitor, but I still get the error.

If you have resolved the error, please help me to fix it.

Thanks you so much,