I was just wondering if there were a way to allow a partial restriction for user access to the phones.
We are looking to deploy restricted access for security reasons, but would like to be able to see the telephone loads and the network information.
Can this be done on restricted access anywhere?
thanks in advance for any help.
Note You can control whether a phone has access to the Settings menu or to options on this menu by using the Settings Access field in the Cisco Unified Communications Manager Administration Phone Configuration window. The Settings Access field accepts these values:
•Enabled—Allows access to the Settings menu.
•Disabled—Prevents access to the Settings menu.
•Restricted—Allows access to the User Preferences menu and allows volume changes to be saved. Prevents access to other options on the Settings menu.
If you cannot access an option on the Settings menu, check the Settings Access field.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...