Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RighFax Problem at configuration

hello,

i have installed the RF9.3 and i have licensed it, the brooktrut is also installed, the email gateway is configured.

I don't know what's the next steps that i must do to success the delivery of faxes.

Thanks at advance

1 REPLY

Re: RighFax Problem at configuration

Sounds like you need to route the DIDs to the brooktrout board right? Is board a T1 or ? Im thinking your board is a T1 card in your RF server. With that in mind, you will connect it your Cisco Router on a T1 card. You will route the incoming DIDs from the PRI through MGCP or H323 back through the T1 card connected to the Brooktrout card. The RF will answer, read the fax, route it to the Exchange mailbox.

Do you have all the installation documentation for the RF server?

115
Views
0
Helpful
1
Replies