I have a really weird issue that I can not figure out. I have a RightFax server running 9.4 SIP to our CUCM 8.0.3 then MGCP to a 2951 router out to the PSTN via a PRI circuit. I have a test PRI that works fine from the PSTN to the RightFax server but when I plug in our production PRI the call is being answer by the RF server but after a few seconds the caller just receives a busy signal. I have captured the ISDN information and it all looks good. The path is the same for both PRI's and I have all the correct settings enabled for T38. Any Suggestion?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...