Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RightFax config for 2911 router and Call Mgr

Hello,

I am trying to configure a POTS line running to an FXO port on a 2911 router.  Currently when i test I get connection (no tones) then the call drops.  My path is PSTN --> FXO --> CM (mgcp) -- RightFax.  I have a route pattern for the number pointing to a trunk configured for connection to RightFax.

Router - 2911 running 15.0(1)MS

Call Manager 8.5

I have enabled T.38 and the appropriate commands and dial peers.  At least to my knowledge.  I attached the mgcp, voiceport and dial-peer config below.  Looking for some advice as to what I may be missing. 

2 REPLIES
New Member

RightFax config for 2911 router and Call Mgr

Hello,

you are calling from external into your mgcp gateway to the faxserver?

Is the Faxserver connected to fxo port 0/2/1 ?

The gateway is properly registered?

Regards,

Sven

New Member

RightFax config for 2911 router and Call Mgr

Yes that is correct.  I found the issue late yesterday.  My device pool in Call Manager was not configured correctly.  I now have this working. 

468
Views
0
Helpful
2
Replies
CreatePlease to create content