Anybody has done the integration mentioned in the subject line. My layer 1 is showing active but layer 2 status is showing TEI_ASSIGNED. Configuration has been attached. Any help would be greatly appreciated.
Layer 2 is mulitframe established after adding the below command, but now the call goes through From VG to Right FAX only once in a while and viceversa also is not working. It keeps giving busy signal. Below is the debug isdn outputs.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.