Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Ring back level when calling Cisco IP Phone from Siemens ISDN phone

Hi people,

I have an issue here,any suggestions?

When calling from Siemens phone to Cisco phone, the "ring back" tone level (before called party is answering the call) is lower than calling from Siemens IP Phone to Siemens IP Phone.

We can't mesure the decibels but seems to be (earing point of view) 50% of the normal Siemens to Siemens call.

I've already changed the "Output Attenuation" in "Product Specific Configuration" of S0/SU0/DS1-0@CVGWSL01

but seems to have no effect.

Here our config :

Siemens optipoint 500 Phone --- Siemens Hipath 4500 PABX --- Q.SIG PRA ---- Cisco 2811 voice gateway --- Cisco Call Manager --- Cisco IP Phone 7940

Our config details :

Product : Cisco 2811

Gateway : S0/SU0/DS1-0@CVGWSL01

Device Protocol: Digital Access PRI

Cisco Callmanager version : 4.1(3)sr1

thanks

KUrt

4 REPLIES
Bronze

Re: Ring back level when calling Cisco IP Phone from Siemens ISD

Try this bug CSCuk37626

New Member

Re: Ring back level when calling Cisco IP Phone from Siemens ISD

Hi,

Not a lot of bug details...but i will check the isdn q931 debug.

So what to do about it then if PI=8?

Hall of Fame Super Gold

Re: Ring back level when calling Cisco IP Phone from Siemens ISD

Don't bother, it's just a random bug like that poster often does.

What you can do, adjust the output gain a little, under voice port.

New Member

Re: Ring back level when calling Cisco IP Phone from Siemens ISD

ok,thanks for the reply.

I will check this...

Kurt

194
Views
0
Helpful
4
Replies
CreatePlease to create content