Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Ring-back Tone

I have this problem, A PBX user places a call to an Cisco IP phone, and does not hear a ringback tone before the call is answered. The cisco call manger is 6.0 version and the H.323 gateway is the 3545 pri gateway. What can I do ?. A Cisco IP phone user place a call to PBX user, and tone ringback is heard.

8 REPLIES

Re: Ring-back Tone

This could be attributed to the fact that the gateway was unable to determine the progress-indicator in the call setup and consequently could not cut-through the audio befor the call was answered.

You could try a couple of commands on the gateway:-

Initially configure the 'voice call send-alert' in global.

If this does not appear to working the configure the following commands on the incoming call-leg dial-peer. These generally hidden commands.

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

Rgds

Allan.

New Member

Re: Ring-back Tone

thanks allan.thomas, but this commands are avalaible in the Cisco 3545 PRI Gateway ?

Re: Ring-back Tone

Apologies for the delay, the information that I have provided in most cases will resolve ringback issues on call-legs between IOS gateways and PBX.

When you mentioned that you had ringback issue, I overlooked the fact that it was not in relation to IOS gateway.

Sorry.

New Member

Re: Ring-back Tone

HI ricardo, have you solve this issue? couse i have the same?, there´s one difference, i have a gateway 2600 series. Could you help me please?

Silver

Re: Ring-back Tone

Have you engaged the MTP in the CUCM by checking the checkbox in the gateway configuration page?

MK

New Member

Re: Ring-back Tone

hi MK

i already did, but don´t work jet. any idea?

thanks for yor help.

Silver

Re: Ring-back Tone

What kind of PBX do you have? Is it connected to a Cisco router? If so, make sure you have the "progress ind setup 3" command under the dial-peer in the router connected to the PBX.

MK

New Member

Re: Ring-back Tone

Hi MK thanks for your help.

i have this scenario:

a PBX Alcatel with a link  E1 QSIG to Cico Router  2620, and the Gateway is registered as H323 gateway at CCM 6. And i already configured "progress ind setup 3" under dial-peer voip. So is there a parameter tha i must to change at the CCM?.

best regards

570
Views
2
Helpful
8
Replies
CreatePlease to create content