Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ring settings modifiable?

Where can I go to change my # of rings on a phone before it goes to vmail? I've looked in enterprise param's (set "ring settings -> True under CCMUser Params). Looked under individual line settings found nothing.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Ring settings modifiable?

Hi John,

To add a note to the good info from Kenneth (5 points for this KM)

Here is the way to change this, "System Wide" just in case :)

Go to Cisco CallManager System Parameters from the Cisco CallManager Administration page. Select Service > Service Parameters.

Select the server to be your IP address and the service to be Cisco CallManager from the drop-down list.

Select Forward No Answer Timer (sec) from the list.

In the Value field, insert the timeout that you would like to configure (the time must be inserted in seconds). The default is 12 seconds.

Click Update on the top of the page.

Note: You do not need to restart the Cisco CallManager service to implement the changes.

From this good doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080111c18.shtml#solution3

Hope this helps!

Rob

4 REPLIES

Re: Ring settings modifiable?

On the DN configuration page, there is a field where you can change the ring duration from the default, and put the amount of seconds you would like the phone to ring before going to voicemail.

Hall of Fame Super Red

Re: Ring settings modifiable?

Hi John,

To add a note to the good info from Kenneth (5 points for this KM)

Here is the way to change this, "System Wide" just in case :)

Go to Cisco CallManager System Parameters from the Cisco CallManager Administration page. Select Service > Service Parameters.

Select the server to be your IP address and the service to be Cisco CallManager from the drop-down list.

Select Forward No Answer Timer (sec) from the list.

In the Value field, insert the timeout that you would like to configure (the time must be inserted in seconds). The default is 12 seconds.

Click Update on the top of the page.

Note: You do not need to restart the Cisco CallManager service to implement the changes.

From this good doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080111c18.shtml#solution3

Hope this helps!

Rob

New Member

Re: Ring settings modifiable?

Rob -you are da man! Thanks for the info; I undestand it completely.

Hall of Fame Super Red

Re: Ring settings modifiable?

Hey John,

You Rock my friend! Have a great weekend :)

Rob

112
Views
5
Helpful
4
Replies
CreatePlease login to create content