Hello All. Currently I have two voice gateways with T1 PRI VWICs in each gateway. We have two campuses and each gateway services a campus. I have a bunch of route patterns which are duplicated for each gateway. Basically this means that to dial a 215 area code number, I have a route pattern to send the calls out one gateway and a route pattern to send calls out of the other gateway depending on what calling search space the dialing phone or device has.
I'm adding a third gateway loaded with VIC-2FXO cards with POTS lines hooked to it. I want to use this gateway to send 911 calls to the PSTN to better identify the calling location. However, I also need the ability to send a 911 call through one of the other gateways in the event that the POTS line is not able to handle the call for any reason.
I assumed I need to go with a Route Group with the POTS enabled gateway listed first, followed by the PRI enabled gateway. The problem I'm having is, if there are any existing route patterns being used by a gateway, that gateway will not appear in the available devices section of the route group config page. Do I have to rip out all of my current route patterns and rebuild them all with route groups or is there a better way to do this? Thanks
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...