Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route list - Route Group search timer Call Manager 4.2

We have a Route list with 2 Route groups. each route group contains 1 H323 gateway. If the first Route group is dead, it takes 10 seconds to search to the secndary H323 Route group.

Is there a timer somewhere to shorten this?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Route list - Route Group search timer Call Manager 4.2

hi

If you shut down the h323 GW the timer you reached is H225 TCP Timer

"H225 TCP Timer : This parameter specifies the preferred H.225 TCP connection timer."

The default is 5 seconds, so I am not sure why it takes 10 sec on your CCM if you have only one GW. If you can upload CCM traces on detailed mode I can tell you if it is doing something else.

Thanks

Pedro

2 REPLIES
Cisco Employee

Re: Route list - Route Group search timer Call Manager 4.2

hi

If you shut down the h323 GW the timer you reached is H225 TCP Timer

"H225 TCP Timer : This parameter specifies the preferred H.225 TCP connection timer."

The default is 5 seconds, so I am not sure why it takes 10 sec on your CCM if you have only one GW. If you can upload CCM traces on detailed mode I can tell you if it is doing something else.

Thanks

Pedro

New Member

Re: Route list - Route Group search timer Call Manager 4.2

Thanks Pedro i will try it

166
Views
5
Helpful
2
Replies