Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route Pattern Creation

If I have 100 offices in different geo locations and I want to route their traffic out of their local gateway, I need to replicate the same route pattern 100 times. Is that correct?  Or is there a better way to do this?  I am running CM 4.2.

Thanks.

2 ACCEPTED SOLUTIONS

Accepted Solutions
Bronze

Route Pattern Creation

I am afraid that is correct.  You would have to duplicate your route patterns to point to individual route lists for every location with a local voice gateway.

Unless you upgraded to 7.x and above in which local route groups would be an option.  Then you could re-use the route patterns that point to route lists with the local route group option, which would route by originating device pool.

Cisco Employee

Route Pattern Creation

On 4.X version you're pretty much looking at doing so, this is no longer needed with 7.X+ as the config is done via local route groups which tackles this.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
4 REPLIES
Bronze

Route Pattern Creation

I am afraid that is correct.  You would have to duplicate your route patterns to point to individual route lists for every location with a local voice gateway.

Unless you upgraded to 7.x and above in which local route groups would be an option.  Then you could re-use the route patterns that point to route lists with the local route group option, which would route by originating device pool.

New Member

Route Pattern Creation

thanks.  I will keep that in mind when we migrate to the newer version.

Cisco Employee

Route Pattern Creation

On 4.X version you're pretty much looking at doing so, this is no longer needed with 7.X+ as the config is done via local route groups which tackles this.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Green

Route Pattern Creation

Hi Kevin,

Just had a look at the BAT tool for CUCM 4.2

Unfortunately bulk import of route patterns is not

on the menu. You are going to be busy with copy and ammending.

Remember to that you need to build each site :-

1)Gateway

2)route group

3)route list

4)route patteren

You can miss out 2) & 3) but you loose flexibility fior the future

Good luck

Regards

Alex

Regards, Alex. Please rate useful posts.
183
Views
0
Helpful
4
Replies