Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Route via Caller-ID CLI

Hey all,

I would like to route a call coming in by CLI rather than destination-pattern. So instead of saying if the destination-pattern is x send to this trunkgroup I'd like to do that based on CLI instead.

Is that possible?

Thanks

Anthony

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Route via Caller-ID CLI

Anthony,

Take a look at the following link.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801c0a88.shtml

Hope this helps. If so, please rate the post.

Brandon

4 REPLIES

Re: Route via Caller-ID CLI

Anthony,

Take a look at the following link.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801c0a88.shtml

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Route via Caller-ID CLI

Hi Brandon,

I tried using the answer-address command but it doesn't seem to work. Should the answer-address be the same as the SIP 'Calling Number'? That's what I'm trying.

Thanks

Anthony

Re: Route via Caller-ID CLI

Yes, I believe so. If you turn on "debug voip dial peer" and make the call, do you see the call hitting the dial peer? What is the calling number?

Brandon

New Member

Re: Route via Caller-ID CLI

Sorted!

It's the other way around for me, I'm going from VoIP to POTS and you have to do that translation stuff that your doc talks of.

Thanks for the help.

Anthony

140
Views
0
Helpful
4
Replies
CreatePlease login to create content