The masks,prefix digits and calling types works like this.
1. If you configure at Route pattern level and have configured NOTHING at route list level, then Route Pattern's will take effect. The changes in the mask is reflected on display of IP Phone.
2. If you configure at route list level and have configured NOTHING at route pattern level then again obviously Route List will take effect but the changes are not reflected on IP Phone display.
3. Suppose your RP is 9.[2-9]XXXXXX.Yoy dialled 6265555 Now if you did a Predot for the Discard digits instruction field at the Route Pattern level and at the Route list level you did a prefix 1515. Your IP Phone will display the called number as 6265555 but the digits sent to the gateway will be 15156265555. So in effect the RP has become just a to0l to update the phone display and do a predot whereas your RL prefixed 1515.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...