Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router 2911 - FXS problem - IPphones

Hi everybody,

I’ve a problem with my FXS config. I’ve a 2911 router and I want to connect two fax .

This my current config:

voice-port 0/2/0

     timeouts interdigit 5

     description FXS PORT 0

     caller-id enable

!

voice-port 0/2/1

      timeouts interdigit 5

      description FXS PORT 1   

      caller-id enable

!

!

dial-peer voice 1 pots  

      destination-pattern 219    

      port 0/2/0

!

dial-peer voice 2 pots

      destination-pattern 220

      port 0/2/1

!

My question is, why I don’t receive the caller-id on my fax/phone. I’ve an other problem, I haven’t the end tone (the tone that we can hear when a phone ring off). I’ve the same problem on my IP Phones.

Can you help me please ?

Kirk

Everyone's tags (5)
7 REPLIES
New Member

Router 2911 - FXS problem - IPphones

No idea ?

Could you help me please

Re: Router 2911 - FXS problem - IPphones

add

answer-address 219

and

answer-address 220

on the applicable ports.

Edit: Good Lord my answer has absolutely nothing to do with your question. I am not sure what I thought I read. I was working on some paging while posting and must have confused the two.

Anyway.........what are the incoming numbers coming in on? FXO ports or a PRI?

New Member

Re: Router 2911 - FXS problem - IPphones

Thanks for your reply.

You want to know what is the phone number displayed?

I haven't FXO ports so i think it's PRI but i'm not sure about this

Kirk.

EDIT: For the dialtone when a phone hangs up, the command for the fxs port is "tone dialtone remote-onhook". This command is on default setting and i haven't again this dialtone. What is the problem? (My ipphones have the same problem...Why?)

        Is it possible to define the same phone number on two FXS ports?

Re: Router 2911 - FXS problem - IPphones

issue the command "show isdn status", what do you get?

New Member

Re: Router 2911 - FXS problem - IPphones

Sorry for this late

it doesn't work!

IOS 15.1 (this command is not recognized)

New Member

Router 2911 - FXS problem - IPphones

Please, help me!

I just want to know how to enable the end-tone on my voip phones and pstn phones. This is the only thing that i want to know today because the other are optionnal.

Thanks

Kirk

New Member

Re: Router 2911 - FXS problem - IPphones

Hi;

Try applying:

cptone (followed by country code i.e. GB for the UK) to the analogue voice ports.

As for the IP Phones if you post the e-phone and ephone-dn configurations I may be able to assist there also.

Hope this works for you I have this set on my FXS port.      

1299
Views
0
Helpful
7
Replies