Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RTP media flow between CUCM and CME Endpoints

Hi,

I am running here CUCM 7 in HQ and some branches IP PHones are registered with that. Also I have CME running in some other branches. What I have noticed is RTP traffic is flowing not between CUCM and CME endpoints. Instead, traffic flow from CME endpoints are destined to CME router and then to CUCM endpoints and vice versa. As far as I know rtp traffic should be in between endpoints. It causes some quality issue to as some of the CME endpoints are not located in same location where CME router located. So in short, How can I make the media traffic directly between the endpoints.

Hope someone can shed light on this subject.

Message was edited by: Shakkeer Bilavinakath

  • IP Telephony
Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

RTP media flow between CUCM and CME Endpoints

That is normal. CME always sends media to the CME router for external calls.

In other words, media flow-around for external calls is not supported, and there is no way to enable it.

5 REPLIES
Hall of Fame Super Gold

RTP media flow between CUCM and CME Endpoints

That is normal. CME always sends media to the CME router for external calls.

In other words, media flow-around for external calls is not supported, and there is no way to enable it.

New Member

RTP media flow between CUCM and CME Endpoints

Thanks for the reply

Hall of Fame Super Gold

RTP media flow between CUCM and CME Endpoints

You're welcome, please remember to rate useful posts clicking on the stars below.

Cisco Employee

RTP media flow between CUCM and CME Endpoints

Shakkeer,

Is your CME router, also a default gateway ( not the voice gateway ) for that branch connecting it to CUCM site ?

GP.

New Member

RTP media flow between CUCM and CME Endpoints

In my scenario, CME is serving two sites. At one site where CME router sits and that is acting as default gateway to CUCM site. In second site CME is only voice gateway and the site got its own Default Gateway to CUCM.

1159
Views
0
Helpful
5
Replies
This widget could not be displayed.