Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Run Route List on all nodes CUCM 8.x

Hi All -

When you check mark this box, the release notes says that it will use all nodes in the cluster to send the call out to its destination. (h323 or SIP).    It seems that if send to CUBEs, the keep alives are getting error messages.  IE, if I have (3) Dial Peers setup to point to CUCM-A, CUCM-B, CUCM-C, but I also have CUCM-D.... do I need to have every CUCM dial peer configured in the CUBE to send the call to for this keep alives to not error out?   Its almost reverse thinking when check marking this box on the Route List/Group instead of CUCM Groups.

291
Views
0
Helpful
0
Replies