My case that i have multilocation and in each site i have a voice gateway and the users have permition to call an outgoing call such as mobile 07XXXXXXX, my point that how can configure this common pattern to be route for each location gateway
You can do this using partition. Setup partitions for each of our sites. Assign device pool of each location to to a distinct partition you created. For example, at site A assign all the devices to partition A. Also assign the site gateway to partition A. Then create a route patter 07xxxxxxx and also assign it to partition A.
For another site assign all devices, gateway and route pattern to partition B, and so on.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...