Hi Every One: I am working on IVR development. I have developed an IVR, every thing is working fine. I have used sayitsmart in my application, the problem occurred when my application request for a prompt from the gateway but didn't find the required prompt. So what happened is , my application didn't get the control back and session remain handed on the vxml server utill session time out occur. So this cause a lot of problem for me.
So what i want is when my application request for the prompt to the voice gate way, it will wait for 5 second, if with in 5 second it didn't get the prompt the control get back to the vxml application and that node can skip and the rest of the flow will continue. Customer call should not end.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...