We recently deployed a new UC560 T1 system. Everything is working great, but I cannot get this call connector toolbar to work for the life of me. When the UC560 was in the test environment the call connector toolbar work perfectly fine, now that the system is in production I get the following error posted below. Username as password are not the issue I have been entering what is listed in CCA for the appropriate username and password fields. We did have the Smart Call connector operator software installed on one PC but that program is pretty useless if you ask me and we have since removed it from that PC. Any ideas on what is happening here? I tried to open a TAC case but they dont support the call connector toolbar. All phones are 7975's
Found Router : 10.1.10.2 TAPI is already registered. Registration rejected. It is most likely your username and password do not match or the phone is being used by some other applications.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.