SCCP 8945 not registering with new instal for 2921 with CME 10.0
I have phones which won't register at all. They seem to be missing files, but I downloaded the CME 10.0 ZIP and TFTPd it to the router and phones have access to all 10 files that I will list below. This is a snip of the failures from the actual phone have been attached. TFTP bindings have been attached. Telephony service and voice service voip config has also been attached. Sho ephone register has also been attached.
Seems like the main problem so far is the phones cannot find the files, but the files needed are no where to be found at cisco.com under the 8945 downloads page.
Looks like I figured this out. I waited 2 days till I asked for help, and right after I wrote this post, I figured it out in an hour. Seems like on CME v 10.0 only version 9.2.2 is supported. Our 8945 phones stated on the back of them that they need firmware version 9.4(1) or higher. This isn't true as we're making calls now from them running 9.2.2.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4