Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SCCP on VG224 with CME 4.3

hi, i have a VG224, i configured(enable)the SCCP with this commands:

sccp local FastEthernet0/0

sccp ccm 192.168.25.1 identifier 1

sccp

!

sccp ccm group 1

associate ccm 1 priority 1

after this a created the dial peer pots with stcapp service, in the CME i created the ephone DNs and configured the auto assign command, but i don't have any results, i think that there is a problem with the SCCP, because i have this resuts

VH224#sh sccp connections

Total number of active session(s) 0, and connection(s) 0

please, tell me if i missed a steps, or give me the steps to do this configuration. THANK A LOT

2 REPLIES

Re: SCCP on VG224 with CME 4.3

have a look at the following configuration guid

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxssccpsplmft.html

good luck

if helpful Rate

New Member

Re: SCCP on VG224 with CME 4.3

hi, thanks for your help, but i used this documentation to configure my VG224, but i think that i missed a configuration on the CME.

373
Views
0
Helpful
2
Replies