Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

SCCP Phones on CUCM 9.X dealy 8-10 sec before dial

Dear all

We have cucm version 9.x and all the phones (6921,89xx) have a delay 8-10 sec to dial the internal extension numbers.

 

Conditions:

First , push the loud speaker  and then dial the extension has a delay (8-10 sec)  before to hear the ringtone ( it like the phone waiting for inter digit timeout.

Second condition if we dial the extension and then push the loud speaker then we don't have any delay to the dial..Its going directly

 

The phones are registered into CUCM via sccp

Any thoughts?

 

Regards

Igrusila

 

 

9 REPLIES

Hi.This because there could

Hi.

This because there could be an overlapping dialplan.

Try to go on "call routing" menu and then "route plan report" and check if you see the called extension in different partitions.

 

 

HTH

 

Regards

 

Carlo 

Please rate all helpful posts "The more you help the more you learn"
Community Member

Hi CarloThis was my first

Hi Carlo

This was my first check

There is no overlaping

We have 10 different locations and all the locations have their extension plan

551x

552x

553x

554x

etc

all the locations have the same behavior.

any other thought?

Regards

 

Hi.Which firmware are those

Hi.

Which firmware are those phones running.

 

Let me know

 

Regards

 

Carlo

Please rate all helpful posts "The more you help the more you learn"
Community Member

All have The latest version

All have The latest version

 

6921 have: SCCP69xx.9-4-1-3SR1

HiThrough Cisco Unified

Hi

Through Cisco Unified Serviceability, select "tools" and "Dialed Number Analyzer" and fill all needed fields with correct info. 

After that, please post a screenshot of the resulting page expanding "call flow" and "route pattern" sub result.

 

Thanks

 

Regards

Please rate all helpful posts "The more you help the more you learn"

When you press # at the end

When you press # at the end of digit by digit dial , do you still see the delay ?

Cisco Employee

Did you check your whole dial

Did you check your whole dial plan??? anything that might contain wildcards and be a match??

Or only for patterns that look like what you're dialing??

HTH

java

if this helps, please rate

www.cisco.com/go/pdi

Hi Igrusila,Can you provide

Hi Igrusila,

Can you provide the following information for a test call with this issue.

>> Calling and called party numbers

>> CSS applied on calling party and the partitions contained in that css, also provide the partition applied on called party

>> Route Plan report

As a test, can you create a new partition ( PT-TEST ) and a new CSS ( CSS-TEST ). Add PT-TEST to CSS-TEST. Now apply CSS-TEST to a DN and try calling a DN which has PT-TEST applied to it. This will rule out any overlapping dialplan issue and you can collect detailed callmanager traces for the call if the issue persists and post it on the forum.

HTH

Manish

Change the Digit Analysis

Change the Digit Analysis Complexity CallManager Service Parameter to "TranslationAndAlternatePatternAnalysis" on all nodes then pull the CallManager traces for one of these calls.

127
Views
5
Helpful
9
Replies
CreatePlease to create content