Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sccp plar phones not automatically dialing

I have an issue when I pick up an analog phone, at first all I get is a dial tone but when I hang it up and pick it up again, then it dials. It is connected to a vg224 and I have the sccp plar dial XXXX commands in there. This really seems to happen more when the phone hasn't been picked up in a while. Anybody run into this issue? The version of IOS on the VG is 12.4(9)T6

Thanks

1 REPLY

Re: sccp plar phones not automatically dialing

if u have this config with FXS port to an analog phon try to make the config like

under the fxs port do:

connection plar [number]

and have a look at the following link

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a008009431b.shtml

good luck

if helpful rate

492
Views
0
Helpful
1
Replies