No, there's no tool. The two systems will no doubt have lots of major and lots of very subtle differences, the only way to do this is to work with the customer to document the existing setup and call flows, and then use your UCCX knowledge to replicate what they have and improve it where possible.
Please rate helpful posts..
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
The nortel script is a free type word pad. You have to write everything- good from being real engineer again as opposed go dragging gui's around. when you start up symposium the only words you get in the default script is "wait 2 " after that you are on your own.
There is no conversion except knowing what the customer wants-sorry
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...