Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Second line ring on cucm 7.1

Hi Everyone,

I just migrated from ccm 4.1 to 7.1 and am learning there are a few differences.  Do you know if I should be able to have a second ring?  Any dn on the second line appearance does not seem to ring.  If this is the case, then what is the use of having a 2 line phone?

Thanks for your help

Chris

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Second line ring on cucm 7.1

Hi Chris,

Yes, this should be most possible

Have a look at the second line on one of the non-functioning phones and

check the (under DN config page);

Ring Setting (Phone Idle) =

Ring Setting (Phone Active) =

Let us know what those are set as.

Cheers!

Rob

3 REPLIES
Hall of Fame Super Red

Re: Second line ring on cucm 7.1

Hi Chris,

Yes, this should be most possible

Have a look at the second line on one of the non-functioning phones and

check the (under DN config page);

Ring Setting (Phone Idle) =

Ring Setting (Phone Active) =

Let us know what those are set as.

Cheers!

Rob

New Member

Re: Second line ring on cucm 7.1

Hi Rob,

Thanks for letting me know it was possible.  I just found i had the phone in the wrong partition. 

Thanks a ton!

Chris

Hall of Fame Super Red

Re: Second line ring on cucm 7.1

Hey Chris,

You are always welcome my friend Not much help, but I'm glad

you got this sorted ...great work!

Cheers!

Rob

609
Views
0
Helpful
3
Replies