Everything works as per the document. That is, when I run the test enum command, the result is as illustrated in the doc.
However, the call is NOT actually extended using the replacement URI. That is the call is never placed to the destination that corresponds to the resulting ENUM query. Instead we simply respond with a 404 Not Found SIP message.
I have a feeling I am missing something but which I can't seem to identify.
I have never had this working.
The ENUM server is running on a Ubuntu linux server using bind9.
From the logs The cube has with reponded "404 Not found" cause =3 as ENUM query fails or not
Hence the ENUM part of the config needs to be checked. I noticed some of the config is different from what is given in the doc . For eg. you have stated e.164.test when it should have been stated as e.164.arpa . Also check the DNS config.
Also on the CUCM set the "Stop Routing on Unallocated Number Flag to False" this will allow calls to completed even if ENUM query fails.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...