Selecting FXO Port Based on ANI address CCM---H323
I was trying to do the selection of outgoing FXO port based on ANI address, I was going through some of the posts https://supportforums.cisco.com/message/383216#383216 also cisco document on this. My issue is call from the CCM is not hiting this perticular VOIP peer, Do i need to do anything in the CCM to make the call to hit this newly created VOIP peer so that it can see the ANI and apply the translation rules.
Steps were :
dial-p v 1 voip
translation-profile (adds a 955 to beginning of called number)
dial-p v 2 voip
translation-profile (adds a 966 to beginning of called number)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...