Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Selecting FXO port from H.323

I have a scenario like 2 local extension 1001 and 1002. and i have 2 Analog line connected to FXO fro eg: A and B. I was asked to configure that if i make call from 1001 to outside my call has to go through FXO line A and from 1002 it has to go to FXO B. As Gateway is configured as H.323 how can i do this set up?

  • IP Telephony
2 REPLIES

Re: Selecting FXO port from H.323

You can do this all on the gateway.

You can create different incoming dial peers, that look like this:

dial-p v 1 voip

answer-address 1001

translation-profile (adds a 955 to beginning of called number)

dial-p v 2 voip

answer-address 1002

translation-profile (adds a 966 to beginning of called number)

dial-p v 3 pots

port 0/0/0

destination-pattern 955.T

dial-p v 4 pots

port 0/0/1

destination-pattern 966.T

That would do it. Alternatively, you could add the prefixes in CUCM by creating different route patterns with different partitions and adding different digits there.

-nick

New Member

Re: Selecting FXO port from H.323

Thanks alot for your reply.. Its working fine...

107
Views
4
Helpful
2
Replies