Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Send a specific number out local gateway

We have 20 locations and each one has a local gateway running h323 and POTS lines plugged into them.  I would like to send one specific number out the gateway locally at each location (4192671234).  I would like the users to be able to dial 74192671234.  The call will be a local call for some gateways and a long distance call for others.  How do I configure a Dial Peer specifically for this number that will let the users dial the number and not need to attach a 1 if they're dialing long distance.  I have my current Dial Peer config below.

dial-peer voice 1 pots
 destination-pattern 2601234567
 direct-inward-dial
 port 0/0/0
 forward-digits 0
 prefix 85000
!
dial-peer voice 2 pots
 destination-pattern 7[2-9].........
 port 0/0/0
 forward-digits 10
!
dial-peer voice 2000 voip
 preference 1
 destination-pattern .
 progress_ind setup enable 3
 session target ipv4:10.1.1.1
 incoming called-number .
 voice-class codec 99 
 voice-class h323 1
 dtmf-relay h245-alphanumeric
 fax rate disable
 no vad
!
dial-peer voice 5 pots
 incoming called-number .
!
dial-peer voice 2001 voip
 preference 2
 destination-pattern .
 progress_ind setup enable 3
 session target ipv4:10.1.1.2
 incoming called-number .
 voice-class codec 99 
 voice-class h323 1
 dtmf-relay h245-alphanumeric
 fax rate disable
 no vad
!
dial-peer voice 3 pots
 destination-pattern 911
 port 0/0/0
 forward-digits 3
!
dial-peer voice 4 pots
 destination-pattern 7911
 port 0/0/0
 forward-digits 3

Everyone's tags (1)
3 REPLIES
Cisco Employee

You should start by

You should start by mentioning if this is CUCM or CME, and version.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Sorry! CUCM 8.6. I guess I

Sorry! CUCM 8.6. I guess I was thinking about the gateway and not the call manager side. Thanks!

Cisco Employee

CSS / partitions and your

CSS / partitions and your dial plan define that (remove/prefix digits)

If they need to add the 1, configure a RP with the 1 they can reach, and make sure to have a matching DP

If they don't need to dial the 1, configure the RP without the 1, and the matching DP in the GW

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
35
Views
0
Helpful
3
Replies
CreatePlease login to create content