Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Send pound sign (#) to sip trunk

Hi,

I have a customer with a cme 8 that needs to send the special code #00 that connects to another system in a sip trunk.

I did a dial-peer with this destinattion-pattern like this:

dial-peer voice 30 voip

description ** #00 call **

destination-pattern #00

rtp payload-type nte 99

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

codec g711ulaw

The calls always fail

I did a "debug voip dialpeer all" and i found that the CME when i call the #00 it see the called number as: T00 and the dial-peer never match

How can i do to make this work?

If i use another special charactar like *00 it works, but is necesary the #00

Regards,

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Send pound sign (#) to sip trunk

IOS uses # as termination key, you can change that with following command:

dial-peer terminator A

http://www.cisco.com/en/US/docs/ios/12_3/vvf_r/vrg_d1_ps1839_TSD_Products_Command_Reference_Chapter.html#wp1114770

HTH,

Chris

2 REPLIES
Hall of Fame Super Silver

Send pound sign (#) to sip trunk

IOS uses # as termination key, you can change that with following command:

dial-peer terminator A

http://www.cisco.com/en/US/docs/ios/12_3/vvf_r/vrg_d1_ps1839_TSD_Products_Command_Reference_Chapter.html#wp1114770

HTH,

Chris

New Member

Send pound sign (#) to sip trunk

Hi Chris

This solve my issue

Thanks a lot

594
Views
0
Helpful
2
Replies
CreatePlease login to create content