Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Send the number and name on Caller ID via ISDN Qsig

Hi, good afternoon!

I need help to set up an ISDN - QSIG

On one side is 5.1 CCM 3725 with a router connected to a PBX Avaya via ISDN Qsig

I need to connect to the environment Cisco Avaya need to know if you can send the number and name on Caller ID

below the current configuration

interface Serial1 / 0:15

No IP address

encapsulation hdlc

logging in the event link-status

isdn switch-type primary-qsig

isdn overlap receiving T302-3000

isdn incoming Voice Voice -

isdn T310 60000

isdn bchan-number-order ascending

isdn sending-complete

No keepalive

No fair-queue

No enable CDP

It is possible, hedge someone tell me?

2 REPLIES
Silver

Re: Send the number and name on Caller ID via ISDN Qsig

VIP Super Bronze

Re: Send the number and name on Caller ID via ISDN Qsig

Yes,

It is possible. These are the features supported with QSIG.

Features Supported

CLIP-Calling Line (Number) Identification Presentation

CLIR-Calling Line (Number) Identification Restriction

© 2006 Cisco Systems, Inc. All right reserved.

Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com

Page 4 of 100

CNIP-Calling Name Identification Presentation

CNIR-Calling Name Identification Restriction

COLP-Connected Line (Number) Identification Presentation

COLR- Connected Line (Number) Identification Restriction

CONP-Connected Name Identification Presentation

CONR- Connected Name Identification Restriction

Sending Alerting Name

CT-Call Transfer (by join)

CFU-Call Forwarding Unconditional (by join)

CFB-Call Forwarding Busy (by join)

CFNR-Call Forwarding No Reply (by join)

CFU-Call Forwarding Unconditional (by Reroute) - see Limitations Section

CFB-Call Forwarding Busy (by Reroute) - see Limitations Section

CFNR-Call Forwarding No Reply (by Reroute) - see Limitations Section

CCBS-Call Completion to Busy Subscriber - see Limitations Section

CCNR-Call Completion No Reply - see Limitations Section

ANF-PR-Additional Network Feature Path Replacement (for Call Transfer by join)

ANF-PR-Additional Network Feature Path Replacement (for Call Diversion by forward switching) - see Limitations Section

ANF-PR-Additional Network Feature Path Replacement (for Trombone connection)

MWI- Message Waiting Indication (lamp ON, lamp OFF)

Have alook at this document ans ee configuration for the callmanager side for QSIG.

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
688
Views
0
Helpful
2
Replies
CreatePlease to create content