EDIT: Oops, think this the wrong forum for this question.
I have the task of integrating the following functionality into our VC++6 application: The ability to send both voice and text messages to an IP phone or group of IP phones. By Voice messages I mean placing a call.
Can someone please direct me to which API(s)/SDK(s) I should use?
I have looked through the CCM_API_Overview_3_3_3.pdf; there are quite a few technologies available. Any assistance in helping me narrow down what I should focus on is much appreciated.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...