Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Set speed/duplex for phone from cucm?

Hi,

We have a few problems with PCs that link via IP phones (7940/41/42's) where they don't auto-negiotiate the speed/duplex properly.

I know you can hard set the S/D via the phone, but is it possible to do from CUCM?

We're using 6.1.2

Thanks

1 REPLY
Super Bronze

Re: Set speed/duplex for phone from cucm?

Hi

It's done from the phone interface only - it's also generally a bad idea. Better to resolve the problem with the NICs that aren't negotiating properly (i.e. upgrade drivers/firmware or replace).


Once you start setting these things on desktops you'll spend the rest of your life checking/re-setting the NIC properties, troubleshooting more performance problems where you have the phone set but the PC loses it's settings (or doesn't get them when swapped out) or the other way round etc etc...

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
216
Views
0
Helpful
1
Replies