03-03-2009 09:17 PM - edited 03-15-2019 04:36 PM
Hi
I am using call manager 6.1(2)
The time on the IP phones are wrong.
I have set up the time zone under the date/time group configuration page on the call manager.
Where can I set the correct date and time on the cisco call manager 6.1(2)?
and how can I synchroize the time betweeo sub and pub for the call manager 6.1(2).
Thanks
kind regards
Rachel
Solved! Go to Solution.
03-03-2009 10:27 PM
yes...
In Os administration page of pub > settings > time
rate if useful..
03-03-2009 10:16 PM
you ca set time in o/s administration page or you can map it to an ntp server
subscriber getting its time from publisher
But for phones you can set ntp reference for phones in administration page
note: In command prompt check
show timezone config
show timezone list
utils ntp config
utils ntp restart
utils ntp start
utils ntp status
03-03-2009 10:23 PM
Hi
if I dont have any ntp server that I can connect to it.. is there any way to just set the date and time on the call manager 6.1 ?
when I was using call manager 4.2.1, I set up the time on the call manager directly previously... is it possible for call manager 6.1(2)?
basically i just need to sychronize the time for pub, sub and unity.
thanks
03-03-2009 10:27 PM
yes...
In Os administration page of pub > settings > time
rate if useful..
03-04-2009 02:47 PM
Yes,
its working now, thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide