Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

set up simulated pstn

how can I set up a simulated pstn connection via a back to back e1 a Catalyst 6509 E1 module ?

thanks

1 REPLY
Green

Re: set up simulated pstn

Its is a CMM or a 6608 module?

If CMM i normally do MGCP one port and other H.323

or 6608 must be MGCP but use to different CCMs.

In CMM dont change network clock or inverted them.

Look in CCO for initial config for MGCP + CCM and just change protocol side and clock source ie

Side A Side B

Network User

internal Line

132
Views
4
Helpful
1
Replies