I have a 6 port E1 CMM Voice gateway module in a 6509 & use Call manager.
Have set up CCM ok to make outbound calls etc & all is working.
I now need to set up some E164 numbers so customers can call inbound. Got my numbers from my SP, how do I set this number up within the Voice Gateway & Call manager. Have tried dial peers & configured the CCM with the e164 number etc but all to no avail.
What is the Gateway configured as on the CallManager ?? If it is MGCP then it would work fine without any changes, provided you have a DN to match on the CM or discarding digits when the call is sent to the CM. But if it is a H.323 Gateway, you would need to route this call the CM for it to make the routing decission.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...