Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Setting up a new 7975G & 7962G on CM 6.x

Hello,

We just purchased a 7975G and 7962G, however when I tried adding the phones the only options I get are the 7975 & 7972 (Non-GiG). Does this matter, can I upload the firmware for these phones so I can have them in my selections.

We have Call Manager System version: 6.1.2.1000-13.

Regards,
Gary

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: Setting up a new 7975G & 7962G on CM 6.x

Hi

'G' on it's own doesn't mean Gigabit - it means 'Global'... i.e. you get sticker, not printed on labels for 'Messages' etc.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
3 REPLIES
Super Bronze

Re: Setting up a new 7975G & 7962G on CM 6.x

Hi

'G' on it's own doesn't mean Gigabit - it means 'Global'... i.e. you get sticker, not printed on labels for 'Messages' etc.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Community Member

Re: Setting up a new 7975G & 7962G on CM 6.x

Thanks for info!

Community Member

Re: Setting up a new 7975G & 7962G on CM 6.x

Also a quick way to verify if its a gig phone or not is to flip it over and loop at the to SW port.  If its gig it will say 10/100/1000 and then you will choose the 79XX-GE.

Anthony

259
Views
0
Helpful
3
Replies
CreatePlease to create content