I have set up the workaround you suggested and it works with one exception, we can't get it to beep once before going off hook. I can get it to ring once but there is nothing in our ring selection that sounds like a beep. Is there anyway to get the phone to signal with a beep before the speaker kicks in? Under the line on device section I have selected the Beep only when the phone is active but that doesn't happen?
Any advice? Please let me know if a beep is possible.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.