Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Setting up Cisco 2911 SIP gateway to provider

Let me preface this with, I am very new to voice.

We have a 2911 sitting behind a Cisco ASA that we are trying to connec to our SIP provider. This provider currently works on a 3CX system that we are migrating to Cisco. Currently all phones in the DP register with our Call man, then are sent to the VG for handling. We can only dial the number associated with the DID and nothing further. It seems as though the registration/authentication to the provider is not happening; configs below:

Any help would be appreciated. Oh, we get the 486 "busy here" indication from debug.

voice service voip

callmonitor

allow-connections sip to sip

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none

h323

  call preserve limit-media-detection

sip

  bind control source-interface GigabitEthernet0/1

  bind media source-interface GigabitEthernet0/1

   outbound-proxy dns:sip.maxo.com.au

  no call service stop

!

dial-peer voice 203 voip

destination-pattern .

session protocol sipv2

session target sip-server

codec g711ulaw

!

sip-ua

credentials username 74310 password 7 00171200025A0F101A30 realm dns:sip.maxo.com.au

authentication username 74310 password 7 120A0411140A08123F3A realm sip.maxo.com.au

registrar dns:sip.maxo.com.au expires 3600

sip-server dns:sip.maxo.com.au

Thanks

Charles

1 REPLY

Setting up Cisco 2911 SIP gateway to provider

it is not all info we need.

where are voice translation rules?

phones connected to fxs? and can call each other?

590
Views
0
Helpful
1
Replies