I am trying to set the storage location in the disaster recovery module in Cisco Call Manager, but it is having trouble logging in to the SFTP server. I can connect to the server manually with the credentials using WinSCP in SSH only mode. When I try to plug the same credentials in to the DR module it gives me a failure (bad username/password). Any idea what I might be doing wrong?
I switched SFTP servers to the one listed in a previous forum string. I am now using freeFTPd and it is working. I had tried CoreFTP miniserver and FTPShell with no success. Thanks for your reply, though.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...