Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SG3 fax connected to VG224 running SCCP

Hi!

I have a SG3 fax connected to a VG224 running SCCP and fax-relay, I have also tried with fax pass-trough without success. Does anyone know of this is a supported setup or do I have to convert to MGCP or use ATA etc...any ideas would be appriciated.

Thanks

Mattias

1 REPLY
Anonymous
N/A

Re: SG3 fax connected to VG224 running SCCP

If modem pass-through is used to send SG3 faxes and Cisco or T.38 fax relay is used to send G3 faxes, you must configure both modem pass-through and fax relay.

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t4/sg3spoof.html

608
Views
0
Helpful
1
Replies