I'm running 12.4.10a on a 2811. When I run sh call active voice com, the second column isn't intuitive.
The router labels the incoming leg as "ANS" and the outgoing leg as "ORG".
If a person calls from the local gateway to a remote gateway, the command output lables the pots leg (incoming) as "ANS". If a person calls the local gateway from the remote gateway, the output labels the voip leg (incoming) as "ANS".
It's confusing because I would expect the incoming call leg to be "ORG" for originate, and the outgoing leg to be "ANS" for Answer. However, this is not the case.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...