Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

sh run config example for SIP TRUNK form UC500

I hope any of you can help me.

I know that UC500's GUI has the option to configure SIP trunks via its GUI.

I have been trying to configure a TRUNK SIP with CME 4.3, I was provided with:

username:user1

password: pass1

domain:test.voip.com

Outbound proxy (IP address):172.16.1.1 (e.g.)

For some reason I can not register in proxy server. I do not what I'm doing wrong, I have test many combination without success.

If any of you can try with UC500's GUI to configure SIP trunk using the info I showed (user,pass,domain,proxy IP) and then send me the "sh run file" I will appreciate a lot.

My main doubt is in the options

-voice service voip (all that must include)

-sip-ua (all options)

-dial-peer ( I know GUI does not provide this info)

regards,

1 REPLY
New Member

Re: sh run config example for SIP TRUNK form UC500

231
Views
0
Helpful
1
Replies