sh run config example for SIP TRUNK form UC500

[filiberto.aguirre]

I hope any of you can help me.

I know that UC500's GUI has the option to configure SIP trunks via its GUI.

I have been trying to configure a TRUNK SIP with CME 4.3, I was provided with:

username:user1

password: pass1

domain:test.voip.com

Outbound proxy (IP address):172.16.1.1 (e.g.)

For some reason I can not register in proxy server. I do not what I'm doing wrong, I have test many combination without success.

If any of you can try with UC500's GUI to configure SIP trunk using the info I showed (user,pass,domain,proxy IP) and then send me the "sh run file" I will appreciate a lot.

My main doubt is in the options

-voice service voip (all that must include)

-sip-ua (all options)

-dial-peer ( I know GUI does not provide this info)

regards,

[cmonks]

Here is the UC500 SIP configuration support page, should have all the info you need.

http://supportwiki.cisco.com/wiki/index.php/Category:SIP/H.323_trunks_-_Cisco_Unified_Communications_500_Series_-_Cisco_Smart_Business_Communication_Systems