cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
281
Views
3
Helpful
4
Replies

Shared DNs

sohaildxbfze
Level 1
Level 1

Hi All,

CCM ver 4.1.3(sr5)

Issue: Configured 03 DNs on 03 devices, but allowing only one DN on each device with appropriate CSS, but as soon as CSS is applied (without selecting "Update Directory Number of All Devices sharing this line") its applied on all devices.

Any suggestions

4 Replies 4

Majdi Harb
Level 3
Level 3

Hi

same DN in the same partition will be a shared line and you cannot assign them two different calling search spaces.

you may change the route partition for each DN to acheive your goal.

hth

/majdi

sohaildxbfze
Level 1
Level 1

issue is same even chanigng the partition

sohaildxbfze
Level 1
Level 1

hi,

appreciate ur efforts my requirement is,

To configure all 03 DNs on 03 devices, but allowing from each device only one DN to dial out...

hope 2 get ur reply

Hi Sohail,

This is working as designed and cannot be configured as you desire :( Have a look at this clip;

If you change the Calling Search Space or Call Forward and Pickup settings on any device that uses the shared line, the changes apply to all devices that use that shared line.

From this good doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edb46.html#wp1026720

You will need to apply the same CSS for the "Shared Line" appearances and perhaps setup a "Private Line" on each of the 3 phones that does allow dial out calls.

Hope this helps!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: