12-04-2013 06:48 AM - edited 03-16-2019 08:42 PM
Hi
Some on please tell whether we can share a DN between the analog phone configured on FXS port & with cisco ip phone on CME.The fxs port is configured on the CME.
Solved! Go to Solution.
12-04-2013 07:10 AM
HI Sulfi,
Yes, this is supported with SCCP endpoints
Cheers!
Rob
"When it comes to luck you make your own "
- Springsteen
12-04-2013 07:10 AM
HI Sulfi,
Yes, this is supported with SCCP endpoints
Cheers!
Rob
"When it comes to luck you make your own "
- Springsteen
12-04-2013 07:20 AM
HI Rob
Below is my config.They are not ringing together & the analog phone rings only when they FWD the ip phone to the extension 777.
====
sccp local Loopback10
sccp ccm X.X.X.X identifier 1 version 4.1
sccp
!
sccp ccm group 1
bind interface Loopback10
associate ccm 1 priority 1
associate profile 1 register CNFRN1
===
voice-port 2/0/4
==
dial-peer voice 777 pots
destination-pattern 777
port 2/0/4
=====
ephone-dn 1 dual-line
number 777
label Reception Desk
name Reception Desk
call-forward busy 498
call-forward noan 498 timeout 15
=
ephone 1
mac-address 001A.2F80.411A
username "ReceptionDesk"
type 7961 addon 1 7914 2 7914
button 1:1 7m5 8m41 9m4
button 10m11 11m9 13m14 14m16
button 15m6 16m19 17m56 18m22
button 19m48 20m38 21m25 22m61
button 23m31 24m32 25m33 26m34
button 27m35 28m2 29m42 30m43
button 31m44 32m45 33m29 34m47
12-04-2013 07:40 AM
Hi Sulfi,
Check out the STCAPP notes and IOS references in this good
thread
https://supportforums.cisco.com/message/4014781#4014781
Cheers!
Rob
"When it comes to luck you make your own "
- Springsteen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide